End Closure for 16mm Polycarbonate Sheets(White, Brown or Anthracite Grey)Seal and protect the ends of your polycarbonate sheetsAlso known as "U" Drips, Poly End Covers and End Profile Trims, these End Closures are designed to protect ends and form a tight seal to the top of polycarbonate sheeting using it's flexible, co-extruded gasket.End closures are typically fitted to the gutter-end of pitched roofs, such as those of a conservatory, or to both ends of a free-standing roof. Provides decorative protection to the vulnerable ends of polycarbonate sheeting.Features & Benefits Seals open end of polycarbonate sheet Helps prevent dust and insects entering the sheet No need to use silicone to seal the end closure Co-extruded gasket stops water penetration from above Protects vented anti-dust breather tape Drip design prevents water from being blown back towards the roof Drainage holes reduce condensation and moisture Extend the life of your roofWith three sides protected by glazing bars and ridge capping, the gutter end is often the only edge of polycarbonate sheets that are exposed. When left exposed, the breather tape that is applied to the open fluted ends of the sheets become wet and deteriorate. This leads to failure of the tape and the sheets flutes suffering condensation, algae build-up and insect penetration. Fitting End Closures helps stop this from happening.These End Closures are designed with a 3mm 'drip' on the front edge, to stop water running back towards the roofing material and drainage holes to ventilate and release any water that gets into the end closure.IMPORTANT SIZE INFORMATION These end closures are designed to fit 16mm thick sheets, and are supplied in 2.1m lengths for white and brown, and 2.5m length for anthracite grey.
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.
