Seal Your AquaJet 1300 Water Chamber Against Debris and Leaks The Aquascape AquaJet 1300 (G2) Water Chamber Cover Kit is a factory replacement water chamber lid for second-generation AquaJet 1300 submersible pond pumps. The water chamber cover seals the impeller cavity from the motor section; a damaged or missing cover reduces pumping efficiency and can allow fine grit to migrate toward the motor bearing. Protect the Impeller Cavity With an OEM Replacement The water chamber is the pressurised section of the pump where the impeller accelerates water toward the discharge. Its cover maintains the boundary between the wet impeller side and the motor housing, and any compromise in that boundary reduces both flow rate and motor service life. This OEM kit includes any associated O-ring or gasket components needed to restore the factory seal specification. Specification Value Compatible Pump Aquascape AquaJet 1300 (G2) Component Water chamber cover with O-ring Fit Type OEM direct replacement How to Use Remove the pump from the water and disconnect from power. Open the pump housing to access the water chamber cover. Remove the existing cover and O-ring. Clean the cover mating surface on the pump body thoroughly. Seat the new O-ring from the kit into the groove, ensuring it lies flat without twists. Fit the new water chamber cover, aligning the retaining tabs, and secure until all clips are fully engaged. Test in a bucket of water before resubmerging. Ideal for servicing AquaJet 1300 G2 pumps in small waterfalls, pond skimmers, and decorative stream channels where the water chamber cover has cracked or the O-ring has failed.
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.
