Product Overview DORMAKABA® Bottom Patch Fittings are designed to be used with our bottom door pivots or floor closers and fit snugly in the lower corner of the glass panel, requiring a hole and cut-out in the glass. They are available in brushed or polished stainless steel finishes. Here are the specifications to be aware of: 2-3/4" (70 mm) Pivot Setback For 3/4" (19 mm) Glass Use Monolithic Tempered Glass When using this hardware, please adhere to the following guidelines: Maximum Height: 102" (2.59 m) Maximum Weight: 194 Lbs. (88 kg) Maximum Width: 42" (1.09 m) If the door exceeds any of these limitations, it is recommended to use full door rails. Glass fabrication requires: One 3/4" (19 mm) Diameter Hole and Corner Notch These fittings come with a template and instructions and adhere to the following product warning: Not suitable for use with laminated glass. Furthermore, please note the Stainless Steel Advisory: While stainless steel is resistant to corrosion, it is not rust or stain-proof. It is recommended to perform periodic maintenance to maintain its factory finish. For further details, please refer to the Stainless Steel Disclaimer in the Technical References section below.
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.
![FHC 10" Pull [1" Diameter Back-To-Back Handle]](https://cdn.shopify.com/s/files/1/1076/9324/4755/files/cp10x10bs-1w.jpg?v=1788648259)
![FHC 6" Single Sided Tubular Pull Handle [No Metal Washers]](https://cdn.shopify.com/s/files/1/1076/9324/4755/files/phrn6ch-1w.jpg?v=1788648279)
![FHC 12" Offset Pull [1" Diameter Back-To-Back]](https://cdn.shopify.com/s/files/1/1076/9324/4755/files/cp012x12bs-1w_1.jpg?v=1788648262)
![FHC 10" Offset Pull [1" Diameter Back-To-Back]](https://cdn.shopify.com/s/files/1/1076/9324/4755/files/cp010x10bs-1w_1.jpg?v=1788648260)