This brass jet tip is designed to typically be used with heated carpet extractors. It features a smaller orifice than the equivalent #3 jet tips that are used on non-heated machines. The smaller jet tips allow less water to be dispersed, and more heat to build up. While compatible with most wands on heated or non-heated machines,this spray jet was specifically made to be used with the EDIC 12" Glidemaster™ carpet wand that goes along with the Galaxy carpet extractor. If your wand stops spraying, the jet tips may be clogged. Try removing and rinsing them with warm water, or soak them in vinegar to dissolve buildup—then flush with hot water. If that doesn’t help, the tips likely need to be replaced. You may also need new check valves with strainers, available in our drag wand jets & parts section. For best performance, we recommend replacing brass jet tips and check valves every 6 months. See the diagram below to identify the parts you need. This listing is for Part B (jet tip). Part A: Threaded Spray Body Cap Part B: UniJet Brass Spray Jet w/ #1.5 Orifice Part C: Teejet Tip Strainer For more replacement components, please take a look at our drag wand jets & parts category.
Checkout happens on the official store. This page mirrors catalog facts in plain HTML for direct reading and crawlability.